3M 5301* Cable Splicing Kit

2201647 MFG #: 5301*
$46.12 / EA
Usually Ships within 5-8 Days
  • Color: Black
  • Conductor Size: 10 to 4
  • Connector Type: Pigtail
  • Dimensions: 4 in L
  • Insulation Size: 0.17 to 0.36 in OD
  • Material: EPDM Rubber
  • Number of Conductors: 1
  • Series: 5300
  • Splice Length: 3.4
  • Temperature Rating (Degrees F): 90 to 130
  • Voltage Rating: 0 to 1000

3M 5301* Cable Splicing Kit

3M™ Motor Lead Splice Kit, Series: 5300, 0 to 1000 VAC, 10 to 4 AWG Conductor, 0.17 to 0.36 in OD Insulation, 3.4 in Splice Length, 1 Conductor, Pigtail Connector, 90 to 130 deg C, EPDM Rubber, Black, 4 in L Dimensions

Additional Description: 3M -5301* ID#80-0080-0641-5 MOTOR LEAD SPLICING KIT, 1PC (3 SPLICES/KIT)

Catalog Description: 3M™ Motor Lead Pigtail Splicing Kits 5300 Series are designed for splicing motor lead cables to incoming feeder cables, including the accommodation of pigtail (stub) connections at 1000 volts and less. The splice’s main component, the slip-on lug cover, is made from EPDM rubber. Mastic strips are used for the moisture seal.These kits are designed to be used with copper compression, one-hole lugs. After being crimped onto the cables, the lugs are bolted together in a pigtail configuration, then insulated and sealed with the 3M Motor Lead Splicing Kit. Each kit makes three splices and contains the necessary materials (except lugs) needed to make three splices. The lugs must be purchased separately. 3M™ Scotchlok™ Copper Compression Lugs 30000 Series, or other UL listed copper lugs, can be used.Kit contents include:• (3) Pigtail lug covers• (3) Mastic sealing strips• (3) Locking pins (kits 5302–5304 only)• (3) Tubes of silicone grease• (1) Instruction sheet

  • Specifications
  • Fast and simple installation
  • 1400 psi tensile strength
  • 1/2 in maximum bolt length
  • Polyethylene cable
  • 10 to 4 AWG feeder cable, 12 to 4 AWG motor lead conductor size
  • Designed to use with copper compression, 1-hole lugs
  • Slip-on lug cover is made of durable EPDM rubber
  • No torches or heat source required
  • No special tools required to install splice
  • Thick walls to resist puncture and abrasion damage
  • High dielectric constant stress control included with 5/8 kV kits for shielded feeder cables for minimizing size and electrical stress
  • Easy re-entry, can be used on cables with a rated operating temperature of 90 deg C and an emergency overload rating of 130 deg C, to splice (insulate and seal) motor lead connections for 1000 VAC and less cables sized 16 AWG to 500 kcmil
  • Suitable for use with 30000 series copper compression lugs or other UL listed copper lugs
  • 365 V/mil dielectric strength
  • 750% elongation