3M 5302 Cable Splicing Kit

2346826 MFG #: 5302
$56.42 / EA
Usually Ships within 5-8 Days
  • Cable Type: Shielded
  • Color: Black
  • Conductor Size: 2
  • Connector Type: Pigtail
  • Insulation Size: 0.34 to 0.54 in OD
  • Material: EPDM Rubber
  • Number of Conductors: 1
  • Series: 5300
  • Splice Length: 4.2
  • Temperature Rating (Degrees F): 90 to 130
  • Type: 3-Cable
  • Voltage Rating: 0 to 1000

3M 5302 Cable Splicing Kit

3M™ Motor Lead Splice Kit 3-Cable Series: 5300 0 to 1000 VAC Shielded Cable 2 AWG Conductor 0.34 to 0.54 in OD Insulation 4.2 in Splice Length 1 Conductor Pigtail Connector 90 to 130 deg C EPDM Rubber Black

Additional Description: 3M -5302 MOTOR LEAD SPLICING KIT (3 SPLICES/KIT)

Catalog Description: 3M™ Motor Lead Pigtail Splicing Kits 5300 Series are designed for splicing motor lead cables to incoming feeder cables including the accommodation of pigtail (stub) connections at 1000 volts and less. The splice’s main component the slip-on lug cover is made from EPDM rubber. Mastic strips are used for the moisture seal.These kits are designed to be used with copper compression one-hole lugs. After being crimped onto the cables the lugs are bolted together in a pigtail configuration then insulated and sealed with the 3M Motor Lead Splicing Kit. Each kit makes three splices and contains the necessary materials (except lugs) needed to make three splices. The lugs must be purchased separately. 3M™ Scotchlok™ Copper Compression Lugs 30000 Series or other UL listed copper lugs can be used.Kit contents include:• (3) Pigtail lug covers• (3) Mastic sealing strips• (3) Locking pins (kits 5302–5304 only)• (3) Tubes of silicone grease• (1) Instruction sheet

  • Specifications
  • Fast and simple installation
  • 4.2 in lug cover length
  • 1400 psi tensile strength
  • 750% elongation
  • 365 V/mil dielectric strength
  • 1/case
  • Three splices
  • 2 to 0 AWG feeder cable, 4 to 1/0 AWG motor lead conductor size
  • Designed to use with copper compression, 1-hole lugs
  • Slip-on lug cover is made of durable EPDM rubber
  • No torches or heat source required
  • No special tools required to install splice
  • Thick walls to resist puncture and abrasion damage
  • High dielectric constant stress control included with 5/8 kV kits for shielded feeder cables for minimizing size and electrical stress
  • Easy re-entry, can be used on cables with a rated operating temperature of 90 deg C and an emergency overload rating of 130 deg C, to splice (insulate and seal) motor lead connections for 1000 VAC and less cables sized 16 AWG to 500 kcmil
  • 5/8 kV shielded and non-shielded feeder cables sized 8 AWG to 500 KCMIL, polyethylene cable, cross linked polyethylene cable (xlp), ethylene propylene rubber cable (epr), copper conductors
  • 3/4 in maximum bolt length
  • 0.95 in id lug cover