SSAC-SYMCOM ARP63S Alternating Relay
Image Disclaimers Message
SSAC-SYMCOM ARP63S Alternating Relay
SSAC-SYMCOM ARP63S Alternating Relay
Part #:ARP63S
SKU #: 2226331
Key Features
Part #:ARP63S
SKU #: 2226331
Brand: Littelfuse
Coil Voltage: 230, 230 VAC
Contact Form: DPDT
Contact Rating: 10 A at 120/240 VAC, 28 VDC
Dimensions: 2.39 in H x 1.78 in W x 3.2 in D
Frequency Rating: 50/60, 50/60 Hz
- Alternating or electrically locked operation flexibility to run unit alternating between the two loads as normal or lock the relay to one specific load
- Low profile selector switch prevents accidental actuation
- LED status indication - visual indication of which load is engaged
- Industry standard base connection flexibility to use in many applications
- Rotary switch allows user to lock internal relay to one specific load
SSAC-SYMCOM ARP63S Alternating Relay
Littelfuse SSAC Alternating Relay, Series: ARP, 50/60 Hz Frequency, 230 VAC Coil, DPDT Contact Form, 10 A at 120/240 VAC, 28 VDC Contact, 8 Pins, Plug-In/Socket Mounting, -20 to 60 deg C, 2.39 in H x 1.78 in W x 3.2 in D Dimensions
Additional Description: LTFS-ARP63S ALTERNATING RELAY 230VAC DPDT 8PIN CROSSWIRE W/SW
Catalog Description: The ARP Series is used in systems where equal run time for two motors is desirable. The selector switch allows selection of alternation of either load for continuous operation. LED’s indicate the status of the output relay. This versatile series may be front panel mounted (BZ1 accessory required) or 35 mm DIN rail mounted with an accessory socket. Operation: Alternating: When the rotary switch is in the “alternate” position, alternating operation of Load A and Load B occurs upon the opening of the control switch S1. To terminate alternating operation and cause only the selected load to operate, rotate the switch to position “A” to lock Load A or position “B” to lock Load B. The LEDs indicate the status of the internal relay and which load is selected to operate. Note: Input voltage must be applied at all times for proper alternation. The use of a solid-state control switch for S1 may not initiate alternation correctly. S1 voltage must be from the same supply as the unit’s input voltag